Black Friday Offer
10% off selected Ethiant radiatorsEnds midnight Mon 30 Nov ·
Shop the sale
Skip to content

Find a radiator to fit your existing pipes

Measure the distance between your two pipes, centre to centre, and we will show you every radiator that fits them — exactly, or with the rigid extensions that close the gap. No lifting the floor, no moving pipes, unless you decide you want to.

Every figure comes from the manufacturer's technical data and is checked by a heating engineer. We show the pipe centres with the valves on, the wall-to-pipe depth (the measurement that catches people out) and the heat output, so the one you pick fits and heats the room.

Browse by pipe centres

Most panel radiators sit between 490 and 1,290mm with the valves on; towel rails between 260 and 710mm. Pick the figure closest to yours — the finder above takes any measurement.

How to measure in two minutes

  1. Pipe centres. Measure from the centre of one pipe to the centre of the other where they leave the floor or wall. If you measured the gap between the pipes instead, add 15mm (one pipe width).
  2. Wall to pipe centre. From the finished wall to the middle of the pipe. Singles usually sit 35–50mm off the wall, doubles and columns 60–95mm, towel rails 60–85mm. Different from the old one means packing the brackets or altering pipework.
  3. Where the pipes come from. Floor pipes with side connections take angled valves; wall pipes take corner valves; underneath connections take straight valves. The pipe centres do not change, the valves do.
  4. Space and heat. Note the wall space and any height limit under a window, and the output of the radiator you are replacing so the new one heats the room as well.

Want the detail? Read how to measure pipe centres, with the millimetre figures and how much difference you can get away with.

Questions people ask before they buy

What does "pipe centres" mean?

Pipe centres are the distance between the centres of the two pipes that feed a radiator, measured where they leave the floor or wall. Manufacturers quote the radiator's own connection centres; with a standard pair of angled or corner valves fitted the pipes sit about 90mm further apart (45mm a side), which is the figure we show.

Do the pipe centres have to match exactly?

Within about 10mm, yes — a valve has a little play. If the radiator is narrower than the pipes by up to 50mm a side, a pair of rigid tail extensions closes the gap and we list those as near fits. A radiator wider than the pipes cannot be adapted; the pipework has to move.

Can I use a radiator that is narrower than my pipes?

Yes. Buy rigid extension pieces (15, 20, 30, 40 or 50mm) and fit one each side between the valve and the radiator tail, splitting the gap evenly. Avoid telescopic tails: they seal on an O-ring and are a common source of drips.

What is wall-to-pipe-centre and why does it matter?

It is the distance from the wall to the middle of the pipe at the valve. A single panel sits closer to the wall than a double or a column, so a swap can leave the new radiator's connections 20–40mm further out than the pipes. Up to about 10mm the valves cope; 10–30mm can be packed at the brackets; more than that means offsets or moving the pipes.

Which valves do I need?

Pipes from the floor with side connections: angled valves. Pipes from the wall: corner valves. Connections underneath the radiator or towel rail: straight valves. The thermostatic head goes on the flow side.

Is my old radiator imperial?

If the width is an odd figure such as 1,143mm (45in), 1,270mm (50in) or 1,346mm (53in), it is. Measure the pipe centres as they are, enter them above, and the near-fit results tell you which metric size drops in and the extension length that makes up the difference.